6 days ago · If it happens that even when the ignition key is turned to the ignition position, the starter motor does not activate, it means that there is a fault that may concern the relay, the brushes, the armature or the pinion drive mechanism; it is therefore necessary to disassemble the motor itself and work on it in order to rearrange it; the starter m1. Sep 22, 2009. #1. Hello, first post on the forum!!! I am trying to replace a broken alternator on my FIAT Panda 1.2 eleganza on a 53 plate. I have removed the OSF wheel and the plastic cover exposing the belt and alternator. However, after removing the two (couldnt find any more) bolts i still can't remove the alternator. With a screwdriver, pry the bendix gear forward to engage it with the ring gear. While keeping the gears meshed, measure the gap between the teeth with a 0.032-inch wire gauge. Surprise—there First of all, make sure that your Fiat Panda is completely turned off and parked safely, then enter the passenger compartment and reach the driver's side. At this point, locate the two screws at the bottom of the dashboard (to the left of the steering wheel) and unscrew them. Finally, remove the plastic panel and immediately behind it, you will
Starter motor failure - again. Last summer the starter motor on my Multijet was intermittent. It would always start, but there was the occasional whirring without engagement. To avoid complete failure, I bought a new starter on 06/08/12 and it was fitted 2 days later (too awkward to do at home without ramps). 13 months later, it has failed.
hi. my 1994 1.0l fuel injection fire wont run. It all of a sudden lost power and started making a slight knocking noise then cut out. When you do eventually
tYBz.